Users Manual

FCC Statement
Any Changes or modifications not expressly approved by the party
responsible for compliance could void the users authority to operate the
equipment.
limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates , uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation . If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of
the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
- Consult the dealer or an experienced radio / TV technician for help.
FCC Radiation Exposure Statement :
This equipment has been tested to comply with FCC RF exposure limits
for use at any distance from the body. However, body-worn or similar
accessories (for example a lanyard or pouch) must not include metallic
parts unless that accessory has been evaluated with the device for
compliance with RF exposure requirements.
Press and hold the side power button for two seconds to start the device.
Press and hold for more than 6 seconds to turn off the device. Switch to
the photo mode through the Home screen , and the avatar that can be
obtained through the camera is displayed on the tft screen. The USB
cable must be connected when working,and the lithium battery is used for
short-term storage to prevent power failure.
This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions : ( 1 ) This device may not cause harmful
interference, and ( 2 ) This device must accept any interference received,
including interference that may cause undesired operation. Exposure
Statement Exposure Statement
Exposure Statement Exposure Statement
Note : This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These