User manual

USER MANUAL PrestoAdvancedAD101_AD301_UG_000_UK
Descriptions and non-contractual illustrations in this document are given as an indication only.
M2M Design reserves the right to make any modification
67
- Keying Mode: IKE with Preshared key
- Phase 1 DH group: Group 2
- Phase 1 Encryption: 3DES
- Phase 1 Authentication: MD5
- Phase 1 SA Life Time: 28800
- Perfect Forward Secrecy: true
- Phase 2 DH group: Group 2
- Phase 2 Encryption: DES
- Phase 2 Authentication: MD5
- Phase 2 SA Life Time: 3600
- Preshared Key: 1234567890
Local Group Setup
- Local Security Gateway Type: SIM card
- IP Address From: SIM 1 (WAN connection is established over SIM 1)
- Local ID Type: IP Address
- Local Security Group Type: Subnet
- IP Address: 10.0.10.0
- Subnet Mask: 255.255.255.0
Remote Group Setup
- Remote Security Gateway Type: IP Only
- IP Address: 172.29.8.5
- Remote ID Type: IP Address
- Remote Security Group Type: IP
- IP Address: 192.168.10.1
Failover
- Enable Tunnel Failover: false
Advanced
- Negotiation Mode: Aggressive
- Compress(Support IP Payload Compression Protocol(IPComp)): false
- Dead Peer Detection(DPD): false
- NAT Traversal: true
- Send Initial Contact: true
-
- Click Start button on Internet Protocol Security page to initiate IPSEC tunnel
On the device connected on PRESTO Advanced router 1 setup default gateway 10.0.10.1
The PRESTO Advanced Router 2 configuration:
Click Network Tab, to open the LAN NETWORK screen. Use this screen to configure LAN TCP/IP
settings. Configure IP address and Netmask.
- IP Address: 192.168.10.1
- Subnet Mask: 255.255.255.0
Press Save to accept the changes.
Use SIM card with a static IP address, obtained from Mobile Operator.
Click WAN Settings Tab to configure parameters necessary for GSM/UMTS connection. All
parameters necessary for connection configuration should be required from mobile operator.
Check the status of GSM/UMTS connection (WAN Settings Tab). If disconnected please click
Connect button.
Click VPN Settings > IPSEC to configure IPSEC tunnel parameters. Click Add New Tunnel button to
create new IPSec tunnel. Tunnel parameters are:
Add New Tunnel
- Tunnel Name: test
- Enable: true