User manual

USER MANUAL PrestoAdvancedAD101_AD301_UG_000_UK
Descriptions and non-contractual illustrations in this document are given as an indication only.
M2M Design reserves the right to make any modification
66
IPSec Tunnel configuration between two PRESTO Advanced Routers
IPSec tunnel is a type of a VPN tunnels with a secure tunneling method. Simple network with two
PRESTO Advanced Routers is illustrated on the diagram below Figure 41. Idea is to create IPSec tunnel for
LAN to LAN (site to site) connectivity.
Figure 41 - IPSec tunnel between two PRESTO Advanced Routers
The PRESTO Advanced Routers requirements:
Static IP WAN address for tunnel source and tunnel destination address
Dynamic IP WAN address must be mapped to hostname with DynDNS service (for
synchronization with DynDNS server SIM card must have internet access)
GSM/UMTS APN Type: For GSM/UMTS networks PRESTO Advanced Router connections may
require a Custom APN. A custom APN allows for various IP addressing options, particularly static IP
addresses, which are needed for most VPN connections. A custom APN should also support mobile
terminated data that may be required in most site-to-site VPNs.
The PRESTO Advanced Router 1 configuration:
Click Network Tab, to open the LAN NETWORK screen. Use this screen to configure LAN TCP/IP
settings. Configure IP address and Netmask.
- IP Address: 10.0.10.1
- Subnet Mask: 255.255.255.0
- Press Save to accept the changes.
Use SIM card with a static IP address, obtained from Mobile Operator.
Click WAN Settings Tab to configure parameters necessary for GSM/UMTS connection. All
parameters necessary for connection configuration should be required from mobile operator.
Check the status of GSM/UMTS connection (WAN Settings Tab). If disconnected please click
Connect button.
Click VPN Settings > IPSEC to configure IPSEC tunnel parameters. Click Add New Tunnel button to
create new IPSec tunnel. Tunnel parameters are:
Add New Tunnel
- Tunnel Name: test
- Enable: true
IPSec Setup