User's Manual

4 / 10

3.2. The wiring diagram

3.3. Install the operating

Step A: install the base (take out 3 bolts 1, plastic pad 2 and support column 3) and tighten them as shown

in the figure above.

Step B: adjust the height of the telescopic rod 5. After knob 4 loosens the screw, adjust the height of the

telescopic rod to ensure that the total height of the support frame is 1.3-1.4 meters (the distance from the

ground to the top of the tablet);

Step C: install the equipment connection plate 6, (take out the thick plastic pad 7, long screw 8, thin iron

pad 9, nut 10, plum nut 11), and install it according to the schematic diagram.

Step D: install the face recognition temperature measuring device 12, align the installation hole on the

back of the device with the hole on the connection plate of the device, and then install and tighten 4 M4

screws 13.Proper adjustment of equipment elevation Angle (or vertical placement) after tightening the

bolts to complete the installation;

Finally, after the power is connected, it can enter the face recognition temperature measurement system.

12V AC Adapter

Android Computer

5.5*2.

5Plug

Relay

COM

Gate