Owner`s manual

WATER MAINTENANCE AND CHEMICALS

LOCK THE SCREEN: Press “UP ” and “DOWN ” buttons together to lock the control panel to avoid any wrong operation by

children. Press the two buttons together once again to unlock.

IMPORTANT：The following conditions will lead to slow water heating

● The ambient temperature is lower than 50°F (10°C).

● Outdoor wind speed is above 8-12mph (3.5-5.4m/s).

● The air bubble function is activated when heating the spa water.

● The spa is not properly covered with the spa cover when the water is heating.

ERROR CODE CHART

LED READING CAUSE SOLUTION

F1-3

F5-7

SPL

SPH

Filter failure

Filter or heating burst into work

Heating failure

Water temperaturer is lower than zero degrees

Water temperature is too high

Water Sanitation

The spa owner must regularly check and keep the spa water sanitized with scheduled maintenance (daily, if necessary). Adding

sanitizer or other chemicals will control bacteria and viruses present in the spa water. The maintenance of a proper water balance

through appropriate use of sanitizers is the most important factor in maximizing the life and appearance of the spa as well as ensuring

clean, healthy and safe water.

Proper technique is important for water testing and treating the spa water. See your spa professional for chemical, sanitizer, test kit

and testing procedures questions.

CAUTION:

● Always follow the chemical manufacturer’s directions, and the health and hazard warning.

● Do not add chemicals if the spa is occupied. This can cause skin or eye irritation.

● Concentrated chlorine solutions can damage the spa tub. Improper chemical use will void the warranty.

Maintenance of Spa Water and Cartridge

Protect all the spa occupants from possible water-related illnesses by keeping the spa water clean and sanitized. Always practise good

hygiene. To ensure proper spa water quality follow these procedures:

1. Inspect and clean the filter cartridge after each use, and change the filter cartridge after it works continuously 72 hours.

Unplug the spa and plug it in again. Reset the GFCI.

If the spa function is still not working, contact the

MSpa Service Centre.

Please contact the MSpa Service Centre.

Unscrew the cartridge assembly from the spa tub wall and remove the cartridge by turning it counter-clockwise (Fig. 1.1).

Use a garden hose to rinse off the cartridge. If the cartridge remains soiled and discoloured it should be replaced. Keep spare

cartridges on hand (Fig.1.2). There are two filter cartridges from the MSpa original package; one is for use, one is spare.

●