Owner`s manual

Nest B-100: For this model, a side bar is included in the package. Set

up the wicker bar and place the supporting legs underneath the spa tub

before filling with water. It helps keep the oval spa in the proper shape

after filling it with water and inflating it.

●

Alpine B-090/091: Spread out the

square ground mat and place it at

the selected site. Make sure the

buckle is cover to the mat is

attached when the spa is not in use.

●

SPA SET-UP

Move the entire package to the selected site. Open the carton carefully, as it can be used to store the spa long-term or when not in

use.

Lay out all the parts on the ground and make sure all parts are accounted for. Make sure the spa tube is right side up. (*For

missing or damaged part, contact the MSpa Service Centre)

Spread the heat preservation ground mat over a cleared area. Spread out the spa liner over the ground mat. Heat preservation

mat prevents heat loss from the bottom of the unit.

NOTE: The heat preservation ground mat is not included for the MSpa LITE package. We suggest finding a ground mat and

puting it between the ground and spa tub to help prevent scratches and heat loss.

NOTE:

1 2 3

Connect the digital cable. Find the

digital cable, the digital cable

cover and the self-tapping screw.

Put the digital cable through the cover, loosen the cap on the end and plug it into the cable port on the control panel. Once the

cable is connected properly and the power is ON, a yellow signal will light up beside the ON/OFF button on the panel. Then secure

the cover onto the control panel using a Phillips screwdriver to tighten the self-tapping screw in the hole in the digital cable cover.

Drill slowly until the screw stops and complete the assembly.

this side

face down