Owner`s manual

RESET
TEST
RESET
TEST
RESET
TEST
10
Verify the supporting floor can support the filled weight of spa with maximum number of occupants. Check with a qualified contractor
or structural engineer to verify the requirement.
Make sure the floor is water resistant and provides non-slip surface. Do not install the spa on a carpet or any other material that could
be damaged by moisture.
Humidity is a natural side effect of installing the spa indoors. The room must be properly ventilated to allow moisture to escape.
Install a ventilating system to prevent excess condensation moisture in the room.
●
●
●
Additional requirements for indoor installation
Make sure to set up the spa on a firm, level and smooth surface that is strong enough to support the full weight of the filled spa and
maximum occupants.
Do not set up the spa on grass or dirt, as this increases the amount of debris entering the spa, and damages the spa floor.
Do not leave the spa tub exposed to direct sunlight for a extend period of time.
It is possible to install and leave the spa outside at a temperature not lower than 39°F(4°C) and the water inside the circulation
system, pump, pipe not frozen. Put a heat preservation mat (*optional) or the electric heating mat (*optional) in between the spa
bottom and the ground to prevent heat loss from the bottom of the spa and to provide better heat retention.
●
●
●
●
Additional requirements for outdoor installation
Plug the machine into the mains.
Press the RESET button on the GFCI. The indicator turns red.
Press the TEST button on the GFCI. The GFCI indicator should shut off. If the GFCI indicator does not turn off, the GFCI is faulty.
Do not use the spa. Contact a qualified electrician to correct the problem.
Press the RESET button on the GFCI again. The indicator should turn red. If it does, the spa is ready for use.
1.
2.
3.
4.
GFCI Testing
! WARNING
Risk of electric shock: This product comes with a GFCI located at the end of the power cord. The GFCI plug must tested before each
use. Do not use the spa if the GFCI plug does not function properly. Disconnect the power cord until the problem has been identified
and corrected. Contact a licensed electrician to correct the problem. There are no serviceable parts inside the GFCI plug. Opening
the GFCI plug will void the warranty.
1. 2.
RESET
3.
TEST
4.
Indicator area