2/5/2015 MSPA FAQ--MSpa Portable Inflatable Bubble Spa
2/5/2015 MSPA FAQ--MSpa Portable Inflatable Bubble Spa | by ORPC--MSpa
http://www.the-mspa.com/care/FAQ.htm 9/10
Answer:
MSpa Series Number locates underneath the control panel and on the spa pool cover, or on the back of
rectangular shape control panel.
48. Question:How much does it cost to run?
Answer:
With a full function and half an hour use, the MSpa will cost approximately ￡5 or €3.2 per day. Each
function on the pump/uses the following:
Massage: 0.5-0.72kW/hr
Filter: 0.035-0.06kW/hr
Heater: 6.75-1.5kW/hr
49. Question:How long does it take to heat up?
Answer:The heat increase rate is maxi. 1.2 to 2.5°C(1-3°F for US) per hour. If the water temperature starts
about 24°C (75F), and you want to warm water to 38°C (100F), it'll take about 7-10hours.
50. Question:If turned off at night time, how much will the temperature drop?
Answer:
From our tests about one degree per 5 hours (based on Spring season outside temperatures).
51. Question:Can I buy filters on the high street?
Answer:
You may be able to, but if you can't then, check with your MSpa local dealer via
52. Question:
How long will my MSpa last?
Answer:
If looked after, your MSpa should last for years.
The blower of bubble has a lifetime. MSpa blower is Quieter & more durable than like product for > 200
Hours – equal to 600 time of use.
For your health concern, MSpa has the auto break design, sets the bubble function for every 20
minutes and auto stop for 10 minutes break. Soaking in the 40°C MSpa for 20 minutes, you can burn
about 200 calories, which equals to:
Brisk walking of 45 minutes at speed of 5.2 km/h
23 minutes ride or ride 4.6 miles
29 minutes yoga exercise
27 minutes diving activities
27 minutes to play sports
4 to 7 km jogging
53. Question:Where should I install the filter cartridge? Why is there hole(s) on the surface of filter
cartridge? Does the filter cartridge have a filter bag?
Answer:Please screw the filter onto the water inlet (lower fitting) on the spa wall by turning it clockwise,
through which water is drawn from the pool by a pump. The hole(s) on the surface of filter cartridge is a
security to make sure there is always minimum water flow to avoid damage to heater and pump when
filter cartridge would be blocked. MSpa does have no cover or bag for the filter cartridge anymore.
54. Question:
Can I use MSpa in the rain?
Answer:
MSpa can leave outside in light rain as it is of IPX5, protection against harmful ingress of water. But we
do not suggest people use it with bubbling open because the water may cause air pump damped and
rusted which could result the air pump works improperly and will void your warranty. And also you’ll
need to make sure to keep the power plug dry.
55. Question:
What if I already screw off the inlet and outlet when the product was full with water??? Did
I hurt the engine?
Answer:No, it’ll not hurt the engine, but the water leakage is a big problem, which would damage or cause
electric shock if there is any other electrical equipment around the spa.