Specifications
air leakage and even the broken of the spa pool. Please pull out the barometer and
then unscrew bottom part of the air valve, let some air out. Check it again with
barometer, till the pin points to the green area.
Note:
1) It is imperative that you test the air pressure inside the spa pool. Over inated spa together with
lled water pressure and sunshine will make the air pressure even bigger.
2) Never over inate your spa.
Unscrew
Valve
Max 38 c
③
. Screw the cover to the valve once the air pressure inside the pool is tested to be
suitable.
j) Open the air valve on the inatable bladder, connect the hose to the air valve and then press the “bubble”
button on the control panel to inate the inatable bladder. Press the “bubble” button again to shut off and
stop inating. In the same way, check and test the air pressure inside the inatable bladder to make sure it
is properly inated.
j) k)
k) Screw the lter onto the water inlet on the spa wall by turning it clockwise
Note:please refer to the I/M of barometer and use the barometer to test and adjust the air pressure
inside the spa pool and the bladder.
l) Fill the Spa
Using a garden hose to ll the Spa at least to the water level printed on the Spa wall.
Warning: make sure the power pack is not plugged in before lling water into the SPA.
l) m)
(m) Place the zipper cover onto the spa and then put the inatable bladder onto the spa pool, Fasten the
zipper and lock the cover to the spa by using the digital lock in the accessory pack
Note: Please remember to test and adjust the air pressure inside of spa pool before each time of
use.