Specifications



b) c) d)
b)Screw the control panel onto the spa, fasten the ring to the pipe adaptor.
c)Connect the connectors. Make sure that the mark of each connector are properly matched together
d)Open the air valve under the control panel. Screw one end of ination hose onto it
e) Unscrew the top part of air valve on the Spa. Connect the other end of ination hose into the valve.
f) As previously outlined, test spa’s RCD plug.
g) Inate the spa pool by pressing the “bubble” button. Press the “bubble” button again to stop inating.
h) Remove the ination hose from the air valve on the spa pool.
Unscrew
Valve
Max 38 c
e) f) g)
i) Use the attached barometer to check and test the air pressure status inside the spa pool in the following
way
Unscrew
Valve
Max 38 c
①
.Inser t the barometer into the valve.
www.the-mspa.com
TM
②
.Check the area that the pin points to.
www.the-mspa.com
Yellow
TM
If the pin points to the yellow area, it means that the spa needs to be inated.
Please pull out the barometer and make further ination.
www.the-mspa.com
Green
TM
If the pin points to the green area, it means the spa is well inated.
www.the-mspa.com
Red
TM
If the pin points to the red area, it means that the spa is over inated, This may cause