Specifications



is level so the spa sits stably and properly.

During lling, emptying or when in use, water may spill out of the Spa. Therefore the spa should be
installed near a ground drain.

Do not leave the Spa’s surface exposed to direct sunlight for long periods of time.
B. RCD Test
WARNING: RISK OF ELECTRIC SHOCK. The RCD plug must be tested before each use.
WARNING: Insert the RCD plug into a residual current device (RCD) protected power receptacle only.
WARNING: Before inserting the plug into a power receptacle, make sure the current rate of the power re-
ceptacle and the xed wiring are suitable for the Spa. Contact a qualied electrician if you cannot verify.
1. Insert the plug into the power receptacle. (1)
2. Press the “RESET” button. The indicator light should turn red. (2)
3. Then press the “TEST” button. The indicator light should disappear. (3)
WARNING: Do not use if above test fails.
4 . Finally, press the “RESET” button again. The indicator light should turn red. The spa is ready for use.
(4)
C. Assembly
(a)
a) Unfold the Spa pool from the packaging.
Spread the Spa and cover. Make sure
both are right side up.
For B-130 and B-140 only
Put the side leather cover on the spa tub.
Attention: make sure the 2 holes on the
leather t the right positions of spa tub.