Specifications

0

Water Filtration Button: This button turns the Filter Pump on and off.
The light of the water ltration button displays green when the ltration system is activated.
Heat Button: Use this button to activate the heating system.
The heater does not stop heating the Spa until the current water temperature reaches 1°C higher
than the setting temperature. Then only the “heater” button is on.
After the current water temperature drops 2°C below the set point temperature the heating system
will restart. The “lter” button will be activated at the same time.
When the light of the Heat Button displays green, the heating system is activate
Heating system is capable of increasing approximately 1.5 to 2°C(3-4°F) per hour.
NOTE: If the heating system is activated the ltration system will automatically start – This is nor-
mal.
Attention: When “HEATER” and “FILTER” both are on, only pressing “HEATER” button can switch
off ltering function but not “FILTER” button.
Bubble Button: Press this button to activate the massage system which has a 30-minute auto shut
off for 10 minutes feature.The light of bubble Button displays green when activated.
Cleaning and replacement of the lter cartridge
Please make sure to unplug the power pack from the electrical receptacle before the follwoing ac-
tions.
(1)
(2)
1. Unscrew the lter cartridge by turning it counterclockwise 2. Remove the lter cartridge cover.
(3)
(4)
3. The Filter Cartridge can be rinsed off with a garden hose and reused. However, if the Filter Cartridge re-