Specifications
0
How to change the combination of digital lock:
1) Original combination is set as 000
2) Push release button
(a) in the direction of the arrow shown and the lock will
be released.
3) Set your desired combination by move the number wheel.
Please do not forget your new combination.
4) Insert back the steel cable to its end in the direction of the arrow.
The new combination is ready for use.
WARNING: Do not move the number wheels while the digital lock is open. Or you will change the
combination you just set. This will unable the digital lock.
WARNING: The cover is not a substitute for adult supervision; Children must be supervised at all
times around the Spa.
WARNING: Water attracts children; Always attach a spa cover and lock it after each use
Power pack operation
Power pack
CAUTION: You must ensure the power pack is prepared before operating, if you do not follow these in-
structions the power may operate abnormally. Never dry-run the power pack as such type of operation will
void the warranty.
Note: The Water in the spa must match the water line printed on the spa pool wall.
Control panel
1. “BUBBLE” Button: To activates Bubbling system
2. “FILTER” Button: To activates Filter system
3. “HEATER” Button: To activates Heating and
Filtering system at the same time
4. “TEMPERATURE” Button: Set and show
water temperature
5. “ ” Button: Higher temperature
6. “ ” Button: Lower temperatrure
LED Display: Once powered-up, the LED displays the
current water temperature automatically.
Press the “ temperature “ button wil cause the led to falsh. When it is ashing, you can set your de-
sired temperature by press the increase and decrease button. Once the desired temperature is set,
press the temperature button again to conrm it.
NOTE: The setting temperature defaults to 40°C
(104°F) when rst plugged in.
NOTE: Temperature adjustment ranges from 20°C
(68°F) to 40°C
(104°F).
(a)
(b)
(c)
(1)
(2) (3)