User manual

Function Failure Alarm on the Control Panel

When power pack doesn’t work properly, there will be

FILTER FAILURE

(A)

HEATER FAILURE

corresponding error code displayed on the control panel in time:

Please check details from troubleshooting page.

BUBBLE FAILURE

Maintaining Spa Water

Poor water quality can be extremely hazardous to your health.

We recommend you do following things:

A: Please use ﬁlter cartridge.

Screw the ﬁlter onto the water inlet (lower fitting) on the spa wall by turning it clockwise.

Note:Two filter cartridge, one is for use, one is spare.

Note: Do not use ﬁlter cartridge when only to heat water or to ensure

good heating performance. To avoid that the ﬁlter cartridge get damaged,

do not use the ﬁlter when there are children or more than two persons in

the pool. After ﬁnish using, replace the ﬁlter cartridge.

B: Clean your ﬁlter cartridge at least once a time after it worked continuously for 72~120 hours. The ﬁlter

cartridge should be replaced at least once a month depending on use.

Please make sure to unplug the power pack from the

electrical receptacle before the following actions.

1. Unscrew the ﬁlter cartridge by turning it counterclockwise.

2. The Filter Cartridge can be rinsed off with a garden hose

and reused. However, if the Filter Cartridge remains soiled

and discolored the Filter Cartridge should be replaced . (1) (2)

The MSpa ﬁlter cartridge has a lifetime of approx. 6 weeks even it’s well maintained. If the paper wall in the

ﬁlter still looks new, it means the ﬁlter can be used for a few more weeks. We suggest preparing more than

one ﬁlter so you can switch between the two ﬁlters when one of them is being cleaned. Make sure the ﬁlter

must be totally dry up before use again. If dusts in the water looks obvious, change the ﬁlter frequently.

C: Change water every few days or use appropriate pool chemicals. All spas require the use of pool chemi-

cals. Please consult your local pool supply retailer for more information about chemical maintenance. Pay

close attention to the chemical manufacturer’s instructions. Spa damage resulting from misuse of chemicals

and mismanagement of spa water is not covered by the warranty.

a. Water Balance: we recommend maintain your water pH between 7.2 and 7.8, total alkalinity between 80

and 120ppm and free chlorine between 3 to 5ppm. Use test strip to test your water chemistry before each

use of the spa, no less than once per week. Low pH will damage to the spa and pump.

Damaged resulting from chemical imbalance is not covered by the warranty.

b. Water Sanitation: Water Sanitation is the responsibility of the spa owner, achieved through the regular

and periodic (daily, if necessary) addition of an approved sanitizer. The sanitizer will chemically control the

bacteria and viruses present in the ﬁll water or introduced during use of the spa.

Note:

1. Leftover chemical from any sources should not be used in the spa tub.

2. Use chlorine powder not tablets to clean the water. Dissolve the power before pour into water.

3. Do not mix the water with any bath oil or bath salt.

4. Only use clean water to ﬁll the spa tub. Salted water could damage the pump and ﬁlter.