music communications system Finish-Out Instructions dmc1

dmc1
www.mssystems.com | 800.421.1587 | www.mssystems.com
Page
5
• Do not over-tighten the screws for the remote stations or the
master as the plastic face panels may crack or strip out.
• Use only M&S Systems certified replacement parts and have them
installed by an M&S Systems dealer or installer. Unauthorized
substitutions can result in fire, electric shock, or other hazards.
• Upon completion of any service or product repair, have the M&S
Systems dealer or installer conduct a safety check to ensure the
system is in proper operating condition.
• Use only a damp cloth to clean the dmc1 master and room stations.
Do not use liquid cleaners or aerosol cleaners.
Finish-Out Instructions
The finish-out installation should be made after the application of wall
covering material.
Tools required:
• #2 Phillips screwdriver
• Standard flat head screwdriver
• Wire stripper/cutter
• Level
Installing the Room Station
Collect all the connectors included in the room
station packages and place them in the wall
housing for use later. At each room station
location, strip approximately 4 inches of jacket
from the CAT5 wire and separate the colored
conductors from one another. Strip ½ inch of
insulation from each conductor as shown in figure 1.
Figure 1 - CAT5 wire