music communications system Finish-Out Instructions dmc1

dmc1
www.mssystems.com | 800.421.1587 | www.mssystems.com
Page
12
Satellite Speakers
At each speaker location, strip approximately 4 Inches of jacket from the
MS2SXSC cables and separate the colored wires from each other. Strip
1/2 Inch of insulation from each wire. Connect the
MS2SXSC cable to the speaker as shown in figure 8.
NOTE: The bare drain wire from the cable is not
connected and should be cut off. On speakers
equipped with RED and BLACK terminals, connect
the BLUE wire to the BLACK terminal and the VIOLET
wire to the RED terminal.
Amplifier Mounting
The amplifier module will install on a single vertical stud previously
marked during rough-in. The vertical height of the
amplifier will allow complete coverage over the wall
openings for the remote volume controls and control
panel wiring. Mark the location of the top mounting
keyhole and bottom mounting holes. With the amplifier
removed verify the location of the vertical stud by
installing the enclosed mounting screws at the marked
locations. Once the location of the stud has
been verified, remove the screws. Remove the
cover from the amplifier. While positioning the amplifier (with cover
removed) into position, bring the volume control and preamp cabling
through the holes provided. Secure the amplifier to the wall in the
Figure 13 – Stereo
wiring connections
Figure 14 – Mono
wiring connections
Figure 16 – Speaker
connections
Figure 17
–
Amplifier mounting