User manual

8
Putting track together
Taking track
apart
Turnout decoders are already built into the turnouts. These can
be operated digitally.
The turnout decoder for the right turnout is preset at MM-/DCC-
Address 5 and the turnout decoder for the left turnout is preset
at MM-/DCC-Address 6.
The procedure for controlling the turnouts digitally can be
found in the operating instructions for your digital controller.
A selection of controllers can be found on Page 28. The turnout
decoder addresses can be changed if desired. See Page 30 to
do this.
7. Functions for the Turnout Decoder
• Capableofmulti-protocols:fx(MM)andDCC
• ModeofoperationsetwithDIPswitches
• AddressescanbesetwithDIPswitches:
1-256fx(MM)(ControlUnit6021/MobileStation
60651/60652)
1-320fx(MM)(CentralStation602xx/MobileStation
60653/60657)
1-511 (DCC)
• ProgrammableaddressesusingCVs
1-2,044 DCC
• ChangestocharacteristicscanbedonewithCVs
• Digitalsignal:transferindependentofthepowersupply
• Powersupplydoneusingthedigitalpowercircuit
• Alternativepowersupply
• Solderpadsforconnectionsforturnoutlanterns
• Turnoutlanternscanbeturnedonoroff