User Manual

Try the menu system

Press and release the Menu button on the remote control. The middle speed

window of the readout will indicate “S n”. This indicates that the squelch is on

and Doppler audio is only present when a target speed is being displayed.

Now, do not push any buttons for 5 seconds. You will notice that the “S n” in

the middle window disappears. In all cases, after the menu buttons have not

been pressed for 10 seconds, the BEE III will revert back to its normal

operating mode.

Press the Menu key again. While the “S n” is being displayed, press the “—”

key on the remote. The middle speed will now read “S f”, indicating that the

squelch is now turned off and that the Doppler audio will be amplified at all

times, even when no target is present. As you have noticed, the “—” key also

acts as an “off” key for the menu. You can turn the squelch on by pressing the

“+” key while the “S” is present in the middle window or turn it off by pressing

the “—” key.

Now try pressing the “+” button without pressing the Menu button first. The

middle speed window of the readout will indicate “A 5”. This is the volume

adjustment, and the current volume setting is now one notch higher than it

previously was. Now wait for the text in the middle window to clear itself

again. Press the “—” button. The middle speed window of the readout will

read “A 4”. The number will be reduced by one from the value that was

previously displayed, indicating that the current volume setting is now one

notch lower than it previously was. Pressing the “+” and “—“ buttons without

pressing the Menu button first is the easiest way to adjust the audio volume.

You can also adjust the volume by pressing the menu key until “A _” is

displayed, where the “_” will be the current volume setting. You can adjust the

volume with the “+” and “—” buttons.

Wait until the middle window clears again and then press the Menu key twice.

The middle window will display “R __”, where the “_” is the current range

setting. Pressing the “—“ button will decrease the range setting by one each

time the button is pressed. To increase the range setting, press the “+” button.

If you press the menu key three times, you’ll notice that the radar will display a

“P” in the middle window. This initiates the POP

™

mode, which will be

discussed in the section on advanced features of the BEE III.