Technical Specifications

INSTALLATION
1. Do not install web swing over concrete, asphalt, packed earth, or any other hard surface. See pages 5-6 for more information on proper protective surfacing material. 2. Confi rm that the supporting structure is secure, it will support at least 600 pounds, is over level ground, has a minimum height of 7ft. and is no less than 6 ft. on all sides from vertical elements. Web swing should have a clearance of at least 1.5 x the total length of all the rope measured from the tree limb/horizontal beam to the metal O ring/s attachment point. 3. Tree Limb Assembly - Test tree limb to ensure that it will hold the weight limit of 600 lbs. safely. Obtain additional rope to attach the Web Riderz to the horizontal (limb) support. The rope used should not be less than the quality, durability and strength of UV stabilized, 1/2” twisted or braided polyethylene rope. For single attachment set up form a small noose at one end of your rope and throw it over the tree limb. For the dual attachment option repeat this step. Run the other end of rope through the noose you created and tighten fi rmly. Run the end of rope through the ,metal ring on the web swing. Tie a minimum of TWO tight knots fi rmly. Repeat for dual attachment. Bottom of swing should be no more than 24” and no less than 18” from the ground. 4. Swing Set or other Horizontal Beam Assembly - Attach the web swing to a swing set by removing two sets of
swings from the existing swing set and attach the upper metal O rings to the chain support hook using carabiniers (not included) rated for at least 600 lbs. Allow 1.5x the total length of the rope to the metal O ring of clearance on each side of the swing from stationary objects or other swinging elements of any kind. Bottom of swing should be no more than 24” and no less than 18” from the ground
Dual attachment exampleSingle attachment example
ADJUST SWING HEIGHT
The height adjustment of your web swing must be made before use. The supporting ropes that go through the swing tubing are not permanently tied. The temporary loop shown below must be undone and a permanent knot must be tied after the height of the swing is adjusted. After the height of the swing is set (see Clearance Requirements below)a permanent knot (as shown below) must be made on each of the ropes to ensure proper use and safety.
Temporary loop
Double overhand knot
Pull tight
At least 6 feet from trunk
or 1½ times the length
of the swings rope
18 inch minumum to 24 inch maximum
ground clearance
Rope
CLEARANCE REQUIREMENTS
OPERATION INSTRUCTIONS
1. An adult should supervise play on this product for children of all ages. 2. Only for family domestic outdoor use. 3. Dress children appropriately, including wearing well-fi tting shoes that fully protect feet. 4. Instruct children: • To avoid swinging empty seats or swings. • To not swing higher than hook attachment. • Get off the swing only after it has completely stopped and to hold the rope until both feet are planted fi rmly on the ground. • To remove articles before playing on equipment that create hazards when they get tangled and caught (examples include: ponchos, scarves, and other loose-fi tting clothing, bike or other sports helmets). • Not to walk close to, in front of, behind, or between moving items.
DO NOT walk in front or behind swing while in motion
WARNING: Never swing higher than hook attachment
MAINTENANCE
INSTRUCTIONS
1. At the beginning of each season and at least twice monthly during usage, treat ropes with a Tefl on-based lubricant. 2. Before each use, check the rope, knots, support and all connections for evidence of deterioration, excessive wear, fractures, breaks or sharp edges and replace as necessary. 3. Take tire swing indoors when the temperature drops below 32 degrees Fahrenheit. WARNING: Failure to carry out these checks and inspections could result in a fall or injury.