User's Manual

3.5.1 Context Preservation

When a reset is caused by the Network Watchdog or by the Reset command (modes 0,1), the

context of the system is being preserved and is restored after the reset. The context includes all

the periodic timers, the report queue, the odometer, etc. This allows to reset the unit as a

troubleshooting measure either periodically or due to Network Watchdog without losing reports

that are already in the queue or are pending on running timers. Note that the reset process may

cause 1-2min of inaccuracy in the timers and should not be considered as very precise.

3.6 Startup Banner

After a reset a startup banner is printed through the UART only. The format and content of

the banner shown below:

FW:<firmware version>; BIN:<bin version>; IMEI:<IMEI>

APN1:<apn1 name>; IP:<IP>:<port>;LPORT:<lport>