User's Manual

Operation RWR95.50
14
2.2 Connection
2.2.1 Electrical Connection
INFORMATION
Wiring diagrams for specific controls and measurement-system combinations are available upon request.
NOTICE
Risk of material damage!
 First set the output signals (refer to chapter 2.3.1), then connect pins 3, 4 and 5.
Fig. 9 Electrical Connection
2.2.2 Output Circuit Pin 3, 4 and 5
Fig. 10 Output Circuit Pin 3, 4 and 5
2.2.3 Input Circuit Pin 6 and 7
Fig. 11 Input Circuit Pin 6 and 7
Pin 1 VDC 12-32 V (<100 mA)
Pin 2 GND 0 V
Pin 3 READY (max. 40 mA)
Pin 4 PROBE (max. 40 mA)
Pin 5 LOW BATTERY (max. 40 mA)
Pin 6 M-Code "A" ON/OFF (Bidi) / GND 0 V (Mono)
Pin 7 M-Code "B" ON/OFF (Bidi) / GND 0 V (Mono)
Pin 8 Temperature measurement analog output
Shield - transparent
white
brown
green
yellow
grey
pink
blue
red
Circuit for outputs
 Pin 3 = READY
 Pin 4 = PROBE
 Pin 5 = LOW BATTERY
Low ≤ GND + 1.2 V
High ≥ VDC - 2 V
RWR95.50
Internal
Signal
VDC (Pin 1)
GND (Pin 2)
Electronic
Fuse
Input CNC
max. 40 mA
RWR95.50
Internal
Signal
VDC (Pin 1)
GND (Pin 2)
Output CNC
max. 1 mA
Circuit for inputs
 Pin 6 = Touch probe "A" ON/OFF
 Pin 7 = Tool Setter "B" ON/OFF
 Pin 6 + Pin 7 = Touch probe "C" ON/OFF
Low < 3 V – min. GND 0 V
High > 10 V – max. 12-32 VDC