User's Manual

Radio-wave Touch Probe RWP38.41
6
Optical Status Display
LED blinking green:
 Probe is transmitting signals
LED blinking green / red:
 Low battery warning
LED blinking orange:
 Stylus deflected
Adjusting Trigger Force (patented)
In case of strong machine vibrations or heavy styli it is recommended to increase probe trigger force.
Attention !
 To adjust trigger force, remove stylus first!
 The lowest trigger force is reached by turning
the Hexagon key counter-clockwise to its limit
 Adjust stylus runout!
 Calibrate probe!
Maintenance
Dirt may accumulate under the metal eyelid
To clean :
 Remove service cover with eyelid and
conical spring by hand.
 Clean probe and parts under
running water.
 Close the probe by hand.
 Align the stylus to spindle centre!
 Calibrate probe!
Attention !
 Do NOT use compressed air or
high pressure water to clean!
 Do NOT use any sharp tools!
(these could damage the inner seal)
Trigger force with
50mm stylus in N
Turns from
lowest force
Z X/Y
min.0 2.5 0.30
1 3.5 0.41
2 4.5 0.52
3 5.5 0.63
4 6.5 0.74
5 7.5 0.85
6 8.5 0.96
7 9.5 1.07
8 10.5 1.18
9 11.5 1.29
max.10 12.5 1.40
Hexagon key
AF1.
3
mm #0227
Service cover #3240
with O-Ring 16x1 Viton #3455
Metal eyelid
#2906
Conical spring
#2931
Factory setting