User's Manual

Operation RWP20.50
30
2.3 Replacing Battery
NOTICE
Risk of material damage!
 Clean and dry the probe well before opening!
 Do NOT blow off with compressed air!
 Replace empty battery immediately!
1. Laterally pull the snap ring off from the probe (1./Fig. 10).
2. Carefully slide the battery compartment sleeve down (2./Fig. 10).
INFORMATION
The touch probe RWP20.50 is protected against wrong polarity. Therefore there is no need to pay attention to the
polarity when inserting a new battery!
3. Take the used battery out of the battery compartment and insert a new battery (3./Fig. 10).
NOTICE
Risk of material damage!
 When closing the battery compartment, ensure the O-ring is properly seated!
4. Carefully slide the battery compartment sleeve upwards (4./Fig. 10).
5. Position the snap ring at the probe laterally and slide it over the probe (5./Fig. 10).
INFORMATION
After changing the battery, the time for starting the touch probe (reboot) is approx. 5 s!
Fig. 10 Battery replacement
O-ring 53.5x1.2 Viton
(1477)
Battery compartment
sleeve
Battery
(9 V, 1200 mAh, lithium)
(5677)
Snap ring
(5525)
2.
1.
3.
4.
5.