Operating Instructions

RC-R-100 Operation
23
2.2.2 Electrical connection to the machine control
INFORMATION
Wiring diagrams for specific controls and measurement-system combinations are available upon request.
NOTICE
Risk of material damage!
• First set the output signals (refer to chapter 2.3.1), then connect pins 4, 5 and 6.
2.2.2.1 Sensor cable pin assignment (receiver)
Electrical connection to the machine control
Pin
Description
1
GND 0 V*
2
12-30 V*
3
ON/OFF (Bidi) / GND 0 V (Mono)
4
Probe (max. 40 mA)
5
READY (max. 40 mA)
6
LOW BATTERY (max. 40 mA)
7
Activation code Bit1 / Serial IN
8
Activation code Bit2 / Serial CLOCK
9
Activation code Bit3
10
Analog output / Serial OUT
11
not assigned
12
Signal Connection
Input (signal from machine control)
Output (signal to machine control)
*The signals can be switched to Pin 1/2. The receiver can be operated
with both polarities.