User manual
ENGLISH
VYSYS CAMERA X10
WIRELESS LCD NVR COMBO
15
Assembly and Commissioning
ASSEMBLY
The camera has 3 holes on its base, which are
intended for fastening the camera. Locate a
suitable place for mounting the camera.
1
The cables should be routed so that they
are protected from manipulation, for
example in a cable duct.
2
If the camera is mounted and operated
outdoors, the two plug connectors may
only be located in a place protected
against moisture. If this is not observed,
corrosion of the plug connectors can occur!
If necessary, use a water-protected
junction box.
3
Use the base of the camera as a template
for marking the drill holes. (Use a drill
suitable for the dowels to drill the holes.
The enclosed dowels require a 6 mm drill)
CONNECTION
•
The camera has a connecting cable with two
plug connectors on the end.
• The RJ45 connector can be used to configure the
camera via Ethernet cable and make it available
to the system.
• The round socket is used to connect the camera
to the external power supply (DC voltage,
12V/DC).
NOTE !
The camera will be damaged if the connection or
voltages are incorrect!
Loss of warranty/guarantee!
• A suitable round connector is required for
connection:
External diameter 5.5 mm,
internal diameter 2.1 mm.
The external contact of the round connector
must have Minus/-, the inner contact Plus/+.
A suitable mains adapter is enclosed, + and -
are labelled correspondingly.