User manual

ENGLISH
VYSYS 1010
WIRELESS LCD NVR COMBO
31
4 Assembly and Commissioning
Note that at night the image is not shown in
colour, but instead in black/white, on a
connected monitor.
ANTENNA INSTALLATION
1
Use a clockwise motion to connect
the antenna.
2
Make sure the antenna is connected
firmly but not excessively.
3
You can adjust antenna horizontal or
vertical direction to get best reception.
TROUBLESHOOTING
No camera image ?
• Set the correct input channel on the monitor.
• Check the voltage/current supply to the
camera.
• Check the cable connections of the camera.
• Check the wireless reception of the camera.
Image too bright ?
• Check the settings in the Setup menu, if
necessary, reset the camera to the factory
settings.
• Do not point the camera towards the sun or
a light.
• Choose corresponding settings in the Setup
menu, e.g. for the white balance etc.
Only black/white camera image ?
• The camera automatically switches over to a
black/white image at night (the IR-LEDs are
activated at the same time). A colour display
is not possible here.