User manual

ENGLISH | BG-1
11
TECHNICAL DATA
Transmitter
Operating voltage: DC 3 Volt (battery
type: CR 2032)
Closed current consumption: <5µA
Current consumption when ringing: <10mA
Frequency: 433.92 MHz
+/- 250KHz
Receiver
Operating voltage: 230V / 50Hz, <1W
Volume: approx. 80 db
Frequency: 433.92MHz
Range: approx. 100m
(open field)
NOTES
The functionality of the unit can be affected by
the influence of strong static, electrical or high
frequency fields (discharging, mobile phones,
radios, microwaves).
Cleaning and maintenance
Always disconnect mains powered units from the
mains supply before cleaning (disconnect the
plug). The unit housing can be cleaned using
a soapy soft cloth. Do not use any abrasive
materials or chemicals. Remove dust build-up
If further transmitters are to be learned after this
then press the CODE button (6) again and then
the new transmitter within 15 seconds. Repeat
this process for further transmitters (up to 4
transmitters are possible).
Set melody
The melody is changed using the side button (4).
Every time the button is pressed the next melody
is played and then saved automatically. There
are 36 melodies to choose from.
Set volume
The volume can be set at one of three levels
using the side button (5). The volume of the
set melody reduces every time the button is
pressed. Once the minimum level is reached
the volume will jump to the loudest level if the
button is pressed again. The volume is saved
automatically.
TROUBLESHOOTING
Receiver does not ring
• Battery in the transmitter empty /
Replace the battery in the transmitter
• Not yet coded / carry out the item ‘Coding’
in these instructions
• Range/ bring the transmitter and the
receiver closer together