Instructions / Assembly

INSTRUCTIONS:

1. Apply tape around edge of window to a clean

dry surface. Wait 10 minutes to apply film to

tape.

2. Unfold film and trim to allow 2" overlap on

all sides of window.

3. Remove protective paper from tape.

4. Press film lightly to tape along top of

window, then lightly stretch film and press to

tape at bottom. Do the same from one side to

the other. Do not stretch film too tight, hair

dryer will stretch film.

5. Reposition film if needed to remove wrinkles.

6. Press film firmly to tape.

7. Apply more pressure for uneven surfaces.

8. With hair dryer on highest setting, pass dryer

over film starting at one corner. Hold dryer 1"

from film. Do not touch film with dryer.

Shrink film until wrinkles disappear.

9. Trim away excess film.

NOTE: Minor scratches, dents and wrinkles on

film surface can be “erased” by re-shrinking

with hair dryer. However, re-shrinking a

puncture will cause the puncture to enlarge.

FOR BEST RESULTS

• Do not apply to wallboard plaster, veneer

paneling, mahogany moulding or peeling

paint.

• Apply to clean, dry surface above 40°F (5°C)

• Remove handle before installing on crank

operated windows.

• Remove tape and film at end of season (Heat

tape with hair dryer to loosen adhesive).

WARNING: THIS PRODUCT CONTAINS PLASTIC

FILM. KEEP AWAY FROM CHILDREN. SUFFOCATION

MAY RESULT FROM MISUSE OF FILM.

PAGE 1
INSTRUCTIONS: 1. Apply tape around edge of window to a clean dry surface. Wait 10 minutes to apply film to tape. 2. Unfold film and trim to allow 2" overlap on all sides of window. 3. Remove protective paper from tape. 4. Press film lightly to tape along top of window, then lightly stretch film and press to tape at bottom. Do the same from one side to the other. Do not stretch film too tight, hair dryer will stretch film. 5. Reposition film if needed to remove wrinkles. 6. Press film firmly to tape. 7.