Operating Manual Electrically heated sample probe tube series SP®, version SP 34-H, SP34-H1.1 and SP34-H2 Gas sampling and gas conditioning technology 2-2.
Dear customer, we have made up this operating manual in such a way that all necessary information about the product can be found and understood quickly and easily. Should you still have any question, please do not hesitate to contact M&C directly or go through your appointed dealer. Respective contact addresses are to be found in the annexe to this operating manual. Please also contact our homepage www.mc-techgroup.com for further information about our products.
Content 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 General information ................................................................................................................... 4 Declaration of conformity .......................................................................................................... 4 Safety instructions ..................................................................................................................... 4 Warranty ..........................................
Head Office M&C TechGroup Germany GmbH Rehhecke 79 40885 Ratingen Germany Telephone: 02102 / 935 - 0 Fax: 02102 / 935 - 111 E - mail: info@mc-techgroup.com www.mc-techgroup.com 1 GENERAL INFORMATION The product described in this operating manual has been examined before delivery and left our works in perfect condition related to safety regulations.
Read these operating instructions carefully before start-up and use of the equipment! The information and warnings given in these operating instructions must be heeded. Work on electrical equipment is only to be carried out by trained specialists as per the regulations currently in force. Attention must be paid to the requirements of VDE 0100 when setting high-power electrical units with nominal voltages of up to 1000V, together with the associated standards and stipulations.
5 USED TERMS AND SIGNAL INDICATIONS DANGER! This means that death, severe physical injuries and/or important material damages will occur in case the respective safety measures are not fulfilled. WARNING! This means that death, severe physical injuries and/or important material damages may occur in case the respective safety measures are not fulfilled. This means that minor physical injuries may occur in case the respective safety measures are not fulfilled.
6 APPLICATION The electrically heated M&C sample probe tube SP34-H is used in extracting portable sampling systems to avoid cooling and condensation of sample in the insitu tube from the sample point to the heated sample probe PSP4000-H. 7 DESCRIPTION The standard length of electrically heated M&C sample tube SP34-H is 1000 mm (other length on request). The sample tube has G3/8" threads on both ends. With the outside thread it will be screwed into the inlet of the sample probe PSP4000-H.
9 TECHNICAL DATA Part No. Temperature sensor Temperature controller Tube length Connections Material Operating temperature Sample temperature Ambient temperature (controller) Power supply Degree of protection / Electrical equipment standard Option: Part No. 02S9036 10 SP 34-H SP 34-H1.1 SP 34-H2 40S9115 40S9120 40S9125 Capillary sensor Fe-CuNi PT100 Thermostate optional, external 1 m standard INLET G3/8" inside thread, OUTLET G3/8" outside thread, DIN ISO 228/T Stainless steel SS316Ti max.
Temperature sensor Figure 3 12 Pin assignment for electrical connection of SP34-H2 and SP34-H1.1 STARTING Prior to starting the device, the system and process-specific safety measures must be observed. For the media to be supplied, the relevant safety requirements and measures must be taken into account. WARNING! WARNING! Before starting up check whether the mains power supply voltage corresponds with the information stated on the nameplate.
13 MAINTENANCE Maintenance of the heated sample tube is limited to the cleaning of the surfaces. WARNING! WARNING! The safety instructions specific to the plant and process are to be consulted prior to any maintenance work! When working during operation: High surface temperatures! Touching the surfaces can result in burns. Wear protective gloves and protect against unauthorized access ! 14 SWITCHING OFF For switching off no specific measures need to be taken.
