User Manual

M&C TechGroup Germany GmbH • Rehhecke 79 • 40885 Ratingen • Germany
[e-mail] • www.mc-techgroup.com • Fon [phone] • Fax [phone]
2.3
Embracing Challenge

Heated sample probe with integrated
valves for:

Calibration gas injection

Probe outlet isolation

Blow back
Special Features
Gas Sample Probe Series SP®
Version SP2200-H/C/I/BB and SP2200-H/C/I/BB/F
SP2200-H/C/I/BB(/F)
Description
The M&C probe SP2200-H/C/I/BB and /BB/F is
based on the standard probe SP2000-H.
• Calibration gas will be injected into the
probe through a check valve /C directly
to the sample outlet. No calibration gas
is lost into the stack.
• An isolation valve /I shuts off the sample
outlet from the internal filter area.
• Through a high flow rate check valve /
BB, which is fixed to the internal probe
area, blow back of the filter housing area
and the insitu probe tube will be done.
• Through a high flow rate check valve /
BB/F, which is fixed to the filter hous-
ing wall, blow back of the incorporated
ceramic filter will be done incl. the filter
area and the insitu probe tube.
Technical specications and illustrations are without
obligation, subject to modications. 10.04/06.06
Following options are included: SP2200-H...
Calibration gas connection tube connector 6 mm o.d.
Blow back gas connection tube connector 8 mm o.d.
Calibration gas injection valve /C
Isolation valve /I
Valve for blow back of the filter housing area /BB
Valve for blow back of the incorporated ceramic filter /BB/F