Operator's manual

7
Gas sampling and gas conditioning technology 2-0.1.1-ME
6 INTRODUCTION
M&C gas sample probes provide direct insitu ultra-fine filtration during continuous gas sampling for
analytic measurements. In this way, part of the necessary maintenance work for a system is concen-
trated on a single point. This filter technology has the major advantage that dust mixtures consisting of
ultra-fine and coarse dusts can be optimally retained with the least possible maintenance work.
Optimal adaptation of the M&C gas sample probe to processing conditions and to measurement work
is a necessary condition for a measurement system to work smoothly. Basically, the gas sample
should be kept to a necessary minimum. This is made possible thanks to optimised downstream gas
processing using M&C components. Only in this way it is possible to reduce maintenance to a mini-
mum while ensuring maximum availability.
7 TECHNICAL DATA
Version SP10
Version SP10-H
01 S 1000
01 S 2000
IP54 EN60529
V10 max.600°C * optional HC max. 900 °C
0,4 bis 6 bar abs.*
-20°C bis +60°C
max. 10 g/m
3
*, optional higher 10 g/m
3
270 mm*
+100 bis +200°C, optional with PT100 without controller
after 1 h
1/8"-NPT internal for tube connectors max. 10mm
230V/50Hz / 240V/60Hz 315W, optional
115V/60Hz 300W
terminals max 4mm
2
, 1x PG13,5 cable gland
EN60529/61010, EN 60519-1
DN65 PN6, Form B , rostfr. Stahl 1.4571
SS316, SS316Ti, Novapress*
4 kg
* Standard
** In case of higher ambient temperatures use option PT100 (Part No. 20S9025) or thermocouple Fe-CuNi respectively Ni-CrNi (Part No.
20S9027 resp. 20S9028) instead of the thermostat controller. Then, an additional electronic temperature controller (see data sheet 2-5.1) is
necessary.
8 APPLICATION