Operator's manual

Gas sampling and gas conditioning technology 2-1.1.7.6-ME

NOTE!

For cleaning the injection nozzle, you need not necessarily pull the nozzle

out of the T-piece. The nozzle can be cleaned together with the complete T-

piece in an ultrasonic bath.

If you blow through the nozzle, this must be done from the jet pipe side.

17 SPARE PARTS LIST

The wear, tear and spare part requirements depend on the specific operating conditions.

The following table shows an extract of the recommended spare parts for the diluiton units DIL-1 and

DIL-1/H :

Recommended spare parts

Part No.

Description

20 S 4300

Complete set critical orifice incl. 2x o-rings. Material: glass # Please specify dilution ra-

tio along with order. #

93 S 4000

Injection nozzle incl. o-ring (crosspiece)

93 S 4006

Dilution crosspiece empty, without any inserts, material: SS316

93 S 4016

Bypass T-piece empty, without any inserts, material: SS316

93 S 4020

Crosspiece complete. # Please specify dilution ration along with order #

93 S 4025

Bypass T-piece complete

90 S 4035

Suction tube for DIL 6x1mm with integrated filter sieve incl. Swagelok® nuts, silver-

plate cutting ring for dilution crosspiece, material SS316

93 S 0010

Spare thermostate 0-180°C

93 S 0015

Spare heating cartridge HLP, 230V 800W

93 S 0017

Spare heating cartridge HLP, 115V 800W

93 S 0018

Heat conductivity paste for insertion of heating cartridge

93 S 4015

Eductor incl. O-ring for bypass-T-piece

18 APPENDIX

Further documentation of our products can be seen in our internet catalogue: