User guide

Session KeyStudio Quick Start Guide
4
|
Installation and Setup Overview
for Windows XP and Windows Vista
It is important that installation and setup take place in the following sequence (all of
these steps are explained in detail later in this Quick Start Guide):
1. Connect the KeyStudio USB MIDI keyboard to your computer and turn it on.
2. Install the Session music creation software. This software enables support for
the M-Audio Micro USB audio interface, and must be installed before Micro is
connected.
3. Connect the M-Audio Micro USB audio interface. This device serves as a high
performance, low latency USB audio interface.
Important: The Micro audio interface and KeyStudio keyboard serve as the copy
protection key for Session. At least one of these devices must be connected to your
computer for Session to launch.
Connecting the KeyStudio Keyboard to your PC
1. Use the provided USB cable to connect KeyStudio to an available USB port on
your computer. The USB cable not only powers the keyboard but also transmits
MIDI data to your computer.
2. Make sure that the power switch on the back of the keyboard is in the “on”
( I ) position. The KeyStudio keyboard is now ready to be used – no additional
installation steps are required.
Windows XP and Windows Vista