User manual

GPS cannot be located when the Immediate Geo-fence function is been executed, GT3000

will use the last known position as the origin of the circular Geo-fence zone to perform the

protection.

US Patten for immediate Geo-fence function is pending.

1.4

TORE AND FORWARD ABILITY

When there is no GPRS service or the server close. The unit will send short message to the

server if defined SMS number. All the stored report will be forward to the server when

GPRS connection is completed next time.

1.5

TCP

AND

UDP

SOCKET SUPPORT

GT3000 supports both UDP and TCP socket communication. The server IP, port number

and socket type can be selected from the PC-setup program or remote server command. In

addition, the connection can be swap over to any server IP or port (either UDP or TCP) via

the air command.

1.6

HE SERVER CAN SEND THE COMMAND TO CONTROL THE

DEVICE AND THE BUILD IN ALARM

Command for in-vehicle control:

We design 8 commands that can be integrated into the server, so that the users can control

their vehicles. Those commands are: (1) Door lock, (2) Door unlock, (3) Arming, (4) Panic,

(5) Enable anti-car jacking, (6) Emergency release, (7) Trunk release, (8) Channel 2

outputs.

OTES

1. Arming (this command is valid only if when ignition is off): If ignition Off,

Server send arming command. The door will lock and the Engine will be Disable

starter (if the starter cut relay connected), after the unit received the command.

2. Panic: (can be performed at any time) If Server send panic command, the horn

will sound and parking lights will flash for 30 seconds after the unit received the

command.