Instruction manual

7
7. Click on “Have Disk....”
8. Insert the PORTMAN PC/P Drivers and Diagnostics disk in Drive
A:\ and click “OK.”
9. The PORTMAN PC/P driver appears in the list. Click on “OK.”
10. Click on “Finish.” Windows will copy the driver files.
11. Check the “Enable Interface” box and select the proper Port
Address and IRQ settings that match the actual hardware settings
of your computer’s printer port.
Typically, LPT1 will be address 3BCh or 378h on a desktop comput-
er. Also typically, if LPT2 is installed, it will be at address 278h.
Usually LPT1 uses IRQ7 and LPT2 uses IRQ5. You may also select
other “non-standard” IRQs if required to do so — checking the
“Use Custom Port/IRQ” checkbox will make “non-standard” IRQs
available for driver use.
If you are unsure of what your Port Address is, please see the sec-
tion in this manual titled “About Your Printer Port,” or consult your
computer’s owner’s manual.
12.Once the Port Address and IRQ are selected, press the <OK> but-
ton.
13.In order for Windows to complete the new driver installation, you
will be required to exit and restart Windows. Select the <Restart
Now> button to do so.
14.Windows will restart. You will then be asked to run the one-time
calibration of the PORTMAN.
Windows 95 Driver Installation
1. Select “Add New Hardware” from the Control Panel. Press the
“Next>” button.
2. Click radio button “No”. You do not want Windows to search for
your new hardware. Click “Next>”.
3. Scroll down in the box and select “Sound, Video and Game
Controllers”. Click “Next>”.
4. Click on “Have Disk...”.
5. Insert the Midiman driver disk in Drive A: and click on “OK”.
6. The PORTMAN PC/P w/LEDs appears in the next box. Click on
“OK”.
7. Click on “Finish”. Windows will copy the driver files.
8. Check the “Enable Interface” box and select the proper Port Address
and IRQ settings that match the actual hardware settings of your