Instruction manual

A:SETUP.EXE if your diskette is in drive A, or type B:SETUP.EXE

if your diskette is in drive B. Now, select the OK button. The

SETUP program will automatically guide you through the instal-

lation and create a MIDIMAN group with a PORTMAN 4x4/S

Remote Control icon.

Remote Control Windows 95 Installation

Windows 95 installation is done as follows:

1. From “Settings” in the “Start” menu, choose Control Panel.

2. Click on “Add/Remove Programs”.

3. Click on “Install”.

4. The Wizard should find the SETUP.EXE program on the A:

drive. If it can’t find it, you will have to type “A: SETUP.EXE”

at the prompt.

5. Click on “Finish”. The Wizard should now install the Remote

Control Windows program.

Typical System Set-up

A typical system set-up (see Fig. 1) consists of your computer

with the PORTMAN 4x4/S installed, your sequencing software, a

tape deck, a Master Keyboard, and additional MIDI sound mod-

ules or keyboards. This set-up is connected as follows:

• The MIDI Out of your Master Keyboard is connected to MIDI

In 1 on the front of the PORTMAN 4x4/S.

• The MIDI Out 1 on the front of the PORTMAN 4x4/S is con-

nected to the MIDI In of your Master Keyboard.

• The MIDI Out of your Master Keyboard 2 is connected to

MIDI In 4 of the PORTMAN 4x4/S. Why connect a master

keyboard to MIDI In 4, you ask? When you are using the

PORTMAN 4x4/S in patchbay mode, program change mes-

sages are received on MIDI In 4, Channel 16. By connecting a

master controller to In 4, you don’t have to change cabling

when using the PORTMAN 4x4/S as a patchbay.

• The MIDI Out 4 of the PORTMAN 4x4/S is connected to the

MIDI In of your Master Keyboard 2.