User guide

Precautions On Use
Please read the following precautions on use before operating the system.
Use the correct power cable for your local power supply.
When disconnecting the power cable, turn off the power and allow at least 30
seconds for any electrostaticity to be discharged.
To avoid electric shocks always plug all cables in to properly grounded power
sources. Do not use adaptor plugs.
Use an uninterruptible power supply, surge processor or line conditioner in order
to protect your system from sudden changes in electrical power.
Location
When running a PAL video monitor with the system there should be a distance of
at least one foot between this and the system monitors, thus avoiding picture
distortion and flickering.
Always place the system on a steady, flat surface and ensure that it is not liable
to fall over.
Do not place the system where it is exposed to direct sunlight, direct heat, high
temperatures or any area where it is in danger of overheating.
Do not place the system near any equipment which generates magnetism.
Do not cover any cooling vents in the system.
Avoid installing the system in a location where humidity, dust and fumes occur.
Caution
Electro Static Discharge, Electrical Fast Transient and Conducted RF interference
may cause the unit to malfunction. In such cases, unplug the unit and plug it in
again to restore normal operation.
Handle With Care
Never use the system during abnormal conditions. Do not operate if smoke is
emitted, sound is frequently distorted, or if there are any conditions of
malfunction.
Do not place any liquids on or near the system.
Ensure that nothing rests on the system’s cables, that they do not come in to
contact with water or excessive heat. Damage to a cable can cause fire or
electric shock. They should be located where they cannot be stepped on or
tripped over.
When not using the system for extended periods make sure that all power cables
are disconnected from the power source.
Disconnect all external leads before shipping. Do not subject the system to
damaging shocks during shipment.
Never remove any covers unless in accordance with the manufacturers’
instructions. Do not place any foreign objects through ventilation holes. If a
foreign object falls inside the system disconnect all power cables and contact
customer support.
Cleaning
Keep your system clean and dust free at all times. To clean use a soft cloth
lightly moistened with a mild detergent. Never use an abrasive pad or solvent
such as benzene or alchol.
Do not allow dust and moisture to accumulate in the surrounding environment.
Important Safety Instructions
When using electric or electronic equipment, basic precautions should always be
followed, including the following:
• Read all instructions before using this equipment.
• To avoid the risk of shock, keep this equipment away from rainwater and
other moisture. Do not use this equipment if it is wet.
• The equipment should only be connected to the correct rating power supply
as indicated on the product.
• Do not attempt to service the equipment. There are no user-serviceable parts
inside. Please refer all servicing to authorized Avid personnel.
• Any attempt to service the equipment will expose you to a risk of electric
shock, and will void the manufacturer’s warranty.
For 240 V AC
For 220 V AC to
240 V AC