Specifications

45
D Redrum
Each column of rotaries corresponds to a drum sound channel on the Re-
drum.
The Bank Left/Right buttons determine which channels are controlled (drum
1-7 or drum 8-10).
The lowest row of rotaries controls drum channel levels, with the rotary but-
tons serving as Solo buttons. The Master Level is on the rotary in the lower
right corner.
The second lowest row of rotaries controls drum channel pan settings, with
the rotary buttons serving as Mute buttons. The Run button is controlled by
the rightmost rotary button in this row.
There are two modes for the rotaries and rotary buttons in the two upper
rows:
In "Pattern mode", the top row buttons select pattern and the first buttons in
the second row select bank.
In "Parameter mode", the rotaries control drum pitch and length, top row but-
tons trigger the drum sounds and the buttons in the second row control the
Decay/Gate switches.
To change mode, use the Parameter (Single) Left/Right buttons.
D BV-512 Vocoder
The rotaries in the lowest row control the basic vocoder parameters.
The second highest row rotaries control the band levels. Which bands are
controlled (1-8, 9-16, 17-24 or 25-32) is selected with the Parameter (Sin-
gle) Left/Right buttons.
D Matrix Pattern Sequencer
The rotary buttons in the second highest row select pattern, and the first ro-
tary buttons in the third row select bank.
The rotary button in the lower right corner controls the Run button.
Control
Requirements/Setting up:
• Reason supports the Mackie Control, or (typically) the Mackie Con-
trol Universal in "Mackie Control" mode.
Reason supports the Mackie Control, or (typically) the Mackie Control Univer-
sal in "Mackie Control" mode.
If you are using a Mackie Control Universal, you need to select the "Mackie
Control" mode of operation: Hold down the SELECT buttons for Ch 1 and Ch
2 and turn on the device - you are then asked which mode of operation to use.
Select "Mackie Ctrl" by pressing the corresponding V-Pot.
You must connect the Mackie Control using two-way MIDI (both MIDI In and
Out should be connected).
Reason will automatically find the Mackie Control if you click the Auto-detect
button on the Control Surfaces and Keyboards page in the Preferences.
About the default mapping:
Note: In the mapping descriptions below, the name labels refer to the default
Logic overlay.
D Global modifiers and modes
Pressing the Flip button swaps the functions of the faders and the rotaries. To
return to the normal mapping, press Global View (next to the Flip button).
Normally, the display shows the name of the currently controlled Reason de-
vice. Pressing the Name/Value button will make the display show the names
of the Reason parameters controlled by the faders instead. Press the button
again to show the device name.
Selecting another target device automatically resets Flip state and display
mode to default settings.