Use and Care Manual

Installation instructions
1. Find your spot. Locate beam, playground, or healthy horizontal tree branch
(branch should be a minimum 8” in diameter). WARNING: Avoid any strap
edges or abrasive contact with strap to maximize life and funcon of strap.
Area surrounding hanging site should be clear of obstacles and over at,
so terrain.
2. Wrap tree strap with limb saver sleeve around a healthy sturdy branch or
other object. Make sure the limb saver sleeve is posioned to make direct
contact with the limb.
3. Next, pass Cyclone Swing Spinner end through the other loop end. The
excess strap should hang from the underside of the branch. (See: Figure A)
4. To adjust the height of the strap connue to wrap the strap around the tree
branch and through the loop mulple mes unl desired length is achieved
(See: Figure B) or create loop with the center of the strap and pull both
ends through (See: Figure C).
5. Pull strap ghtly to secure against branch.
6. Aach your swing securely to Cyclone Swing Spinner using oponal
carabiner or by aaching swing hanging hardware directly to the lower
poron of swivel spinner.
IMPORTANT
Check your Cyclone Spin Kit+ frequently for signs of wear. If any part of the
kit is worn down, do not use.
Tree strap safely supports maximum weight of 800 lbs.
M&M Sales Enterprises, Inc.
Dubuque, IA 52002 | 877-242-0154
www.mandmsalesinc.com
A
B C