Instructions / Assembly

INSTALLATION

1. Do not install tire swing over concrete, asphalt, packed earth, or any other hard surface.

See pages 6 for more information on proper protective surfacing material.

2. Con rm that the supporting structure is secure, it will support at least 200 pounds, is

over level ground, and is no less than 6 ft. from vertical elements on all sides.

3. Tree Limb Assembly

• Test tree limb to ensure that it will hold the weight limit of 200 lbs. safely.

• Form a small noose at one end of your rope and throw it over the tree limb.

• Run the other end of rope through the noose you created and tighten  rmly.

• Run the end of rope through the loop on the tire swing.

• Tie a minimum of TWO tight knots  rmly. Bottom of swing should be no less than 8

inches from ground. See  gure 2.

4. Swing Set or other Horizontal Beam Assembly

Attach the tire swing to a swing set by removing one set of chains from an existing swing

and attach the upper loop (above the PVC separator bar) to the chain support hook on the

underside of the swing set crossbar. Then close the hook. See  gure 1.

Allow 6 ft. of clearance on each side of the swing from stationary objects or other swinging

elements of any kind. Bottom of swing should be no less than 8 inches from ground. See

 gure 2.

Figure 1

Open hook

and hang swing

Close hook

PVC spreader bar

More Fun Products from

Big Buck Tire Swing - MM00114

Chopper Ride’n Tire Swing - MM00117

Air Riderz

Extreme

MM00118

Air Riderz

with Disk

MM00128

Pony Pal Tire Swing - MM00107

WebRiderz Swing - MM00124