Installation Instructions

Page 3
13
Top and bottom panels should
look like this.
14
Trial t all panels to ensure a
proper t. Remove panels from
window frame.
15
Peel back protective lm from all
panel edges to allow room for
caulk.
Protective Film
16
Apply adhesive on back of all
panels using an "S" pattern.
17
Evenly trowel adhesive.
Failure to trowel adhesive
will result in an uneven nish.
Follow adhesive manufacturer’s
instructions. Repeat for all
panels.
18
Place each panel on designated
area of window frame and
press rmly. Allow adhesive to
fully cure. Caulk all seams with
a high grade color coordinated
or clear caulk. Allow caulk to
fully cure per manufacturer's
instructions. Remove all
protective lm.
Protective Film
10
Use a utility knife and straight
edge to cut marked locations.
11
Measure and mark 2" in on at
panel edges. Do not mark ap.
2" Flap will not be cut.
2"
2"
Flap
12
Cut both markings on at panel
using a straight edge and utility
knife.