Installation Instructions

ManualsBrandsLyons ManualsBathWindow Trim Molding

Page 1

Subject to manufacturing tolerance of [+] or [-] 1/8"

Kit Includes:

4 - Window Trim Panels

SUPPLIES YOU WILL NEED:

3 Tube of adhesive compatible with polystyrene

1 Tube of color coordinating or clear caulk

TOOLS YOU WILL NEED:

Tape Measure

36" Straight Edge

Pencil or Marker

Utility Knife

Caulk Gun

Safety Glasses

Notched Trowel

DO NOT RETURN PRODUCT!

FOR QUESTIONS OR CONCERNS

please call or e-mail our customer support team

8:00am-4:30pm EST. Monday - Friday

1-800-458-9036

lyonssupport@lyonsindustries.com

IMPORTANT

• Read installation instructions carefully BEFORE starting project.

• Peel back corner of protective lm to verify color before installation.

• Leave protective lm on during installation.

• Allow panels to reach room temperature before installation.

• Do not use plumber’s putty. This will cause product failure and void warranty. Use a

high grade silicone caulk for all necessary locations.

• Keep instructions for warranty information.

Window Trim Kit

(WTxxx-02)

36"

2" Flap

Summary of content (4 pages)

PAGE 1
DO NOT RETURN PRODUCT! FOR QUESTIONS OR CONCERNS please call or e-mail our customer support team 8:00am-4:30pm EST. Monday - Friday 1-800-458-9036 lyonssupport@lyonsindustries.com TOOLS YOU WILL NEED: SUPPLIES YOU WILL NEED: Tape Measure 36" Straight Edge Pencil or Marker Utility Knife Caulk Gun Safety Glasses Notched Trowel 3 Tube of adhesive compatible with polystyrene 1 Tube of color coordinating or clear caulk IMPORTANT • Read installation instructions carefully BEFORE starting project.
PAGE 2
Installation Instructions 1 2 3 Top window trim stays in place Remove window molding or other projections so window frame is flush with wall. 4 If the window extends above the tile / wall surround or is higher than 36" then only three panels are required and top section of trim will stay in place. 5 Measure height and depth of window frame. 7 Scrape inside window frame to remove loose paint or caulk. Window frame and wall must be smooth and free of any soap residue, wax or oil.
PAGE 3
10 12 11 Flap 2" 2" Use a utility knife and straight edge to cut marked locations. 13 Measure and mark 2" in on flat panel edges. Do not mark flap. 2" Flap will not be cut. 14 Cut both markings on flat panel using a straight edge and utility knife. 15 Film ve cti te Pro Top and bottom panels should look like this. 16 Trial fit all panels to ensure a proper fit. Remove panels from window frame. Peel back protective film from all panel edges to allow room for caulk.
PAGE 4
CLEANING Do not use any abrasive cleaners or metal scrapers. If drywall mud or plaster gets on finished surface, it may be carefully removed with a wooden scraper made from a piece of scrap wood. Any excess adhesive should be cleaned up immediately using mineral spirits or WD-40®. DO NOT USE LACQUER THINNER, it will damage surface of wall. Ideal cleaners are 409®, Soft Scrub Gel®, or Comet Gel®. WARNING: Some cleaning products are not suitable for use. Read all labels carefully.