Installation Instructions

ManualsBrandsLyons ManualsBathPalm Springs 60" x 32" White Bathtub Wall Surround

Page 1

Subject to manufacturing tolerance of [+] or [-] 1/8"

Palm Springs™

(PSSxx603259)

Kit Includes:

1 - Back Panel and 2 - Side Panels

NOTE: Back wall panel is 60" x 59" and two side panels are 31⁄" x 59

Palm Springs™ Tile

(PSTxx603259)

DO NOT RETURN PRODUCT!

FOR QUESTIONS OR CONCERNS

please call or e-mail our customer support team

8:00am-4:30pm EST. Monday - Friday

1-800-458-9036

lyonssupport@lyonsindustries.com

SUPPLIES YOU WILL NEED:

6 Tubes of adhesive compatible with polystyrene

1 Tube of color coordinating or clear caulk

Caulk (for faucet installation)

Masking Tape

Material for creating cross bracing (see step 17)

TOOLS YOU WILL NEED:

Tape Measure

Pencil or Marker

Utility Knife

Caulk Gun

Notched Trowel

Safety Glasses

IMPORTANT

• Read installation instructions carefully BEFORE starting project.

• Leave protective lm on during installation.

• Allow panels to reach room temperature before installation.

• Place towel bars in position before applying adhesive.

• Not designed for unheated properties. Freezing temperatures could cause cracking.

• Keep instructions for warranty information.

Summary of content (4 pages)

PAGE 1
DO NOT RETURN PRODUCT! FOR QUESTIONS OR CONCERNS please call or e-mail our customer support team 8:00am-4:30pm EST. Monday - Friday 1-800-458-9036 lyonssupport@lyonsindustries.
PAGE 2
Installation Instructions 1 3 2 Drywall sets above bathtub flange Bathtub Flange Remove faucet handles, trim, faucet spout and shower door/ curtain. 5 Wall kit may be installed over existing tile. 6 SID EP AN EL 4 Replace damaged or standard drywall with waterproof board. Waterproof board must be installed to studs above bathtub flange for a plumb surface. Measure width of alcove. Top, center, and bottom. Repeat for left and ride side of alcove.
PAGE 3
12 10 11 Apply poly styrene compatible adhesive below marked line on back wall in an "S" pattern. Evenly trowel adhesive. Failure to trowel adhesive will result in an uneven finish. Place back panel and press firmly in place. Be careful not to get glue on finished edges. Repeat steps 10-12 for side panels. ve cti e t Pro Film 16 15 Protective Film Protective Film ve cti e t Pro Film Make sure wash cloth bar is in position.
PAGE 4
CLEANING Do not use any abrasive cleaners or metal scrapers. If drywall mud or plaster gets on finished surface, it may be carefully removed with a wooden scraper made from a piece of scrap wood. Any excess adhesive should be cleaned up immediately using mineral spirits or WD-40®. DO NOT USE LACQUER THINNER, it will damage surface of wall. Ideal cleaners are 409®, Soft Scrub Gel®, Bar Keepers Friend, or Comet Gel®. WARNING: Some cleaning products are not suitable for use. Read all labels carefully.