Installation Instructions
Page 4
LYONS BATHING FIXTURE — LIMITED WARRANTY
10-YEAR CONSUMER, 3-YEAR COMMERCIAL
Lyons Industries, Inc. warrants to the original purchaser that this Lyons bathing xture will be free of manufacturing defects, which aect its performance as a bathing or showering xture, under the
following conditions and subject to the limitations contained in the ”Remedies” and ”Warranty Limitations” sections. The Limited Warranty applies for 10 years from the date of purchase if the xture is
used in a residential owner-occupied building for non-commercial purposes; or for 3 years from the date of purchase if it is used in any other building, including any building used for rental, commercial,
or business purposes. This Limited Warranty is void if the xture is not installed in accordance with the installation instructions supplied by Lyons, or local building codes and ordinances, or if the care and
cleaning instructions supplied by Lyons are not followed. This Limited Warranty is also void if the xture is moved from the location of its initial installation, or is subjected to accident, abuse, or misuse. The
Limited Warranty excludes normal wear and tear, and does not cover damage that can be repaired by following the Scratch Removal Instructions. This Limited Warranty shall be void unless any failure or
non-conformance is discovered before the expiration of this warranty, and is reported to Lyons, in writing, accompanied by the original proof of purchase, within 30 days of discovery, to: Lyons Industries,
Inc., 30000 M-62 West, Dowagiac, Michigan 49407
REMEDIES — The original purchaser’s remedy under this Limited Warranty is limited to the repair, replacement, or refund of the purchase price of the xture, at Lyons sole option, of any part of the xture
which has failed or does not conform to the manufacturer’s specications. In no event shall Lyons be liable for lost prots, loss of use, incidental, special or consequential damages including, but not limited
to, damage to or loss of use of the building or its contents, arising out of any defect in the xture; nor shall Lyons be liable for any amount in excess of the original purchase price of the xture. Lyons
reserves the right to require the return, at purchaser’s expense, of the damaged xture for repair or exchange before providing services under this Limited Warranty. If Lyons elects to replace the xture,
its obligation is limited to supplying a replacement unit or component part of comparable size and style, and does not include the cost of removal, installation, or transportation, which must be borne by the
purchaser. Replacement parts provided under this Limited Warranty are warranted for the remainder of the original warranty period applicable to the xture, as if such parts were original components of
that xture.
WARRANTY LIMITATIONS — THERE ARE NO WARRANTIES WHICH EXTEND BEYOND THE DESCRIPTION ON THE FACE HEREOF. IMPLIED WARRANTIES, INCLUDING THOSE OF MERCHANTABILITY OR
FITNESS FOR A PARTICULAR PURPOSE, ARE EXPRESSLY DISCLAIMED. LYONS DISCLAIMS ANY AND ALL LIABILITY FOR SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES. Some states do not allow
limitations of incidental or consequential damages, so the above limitations and exclusions may not apply to you. In such states, Lyons’ liability shall be limited to the extent permitted by state law. ANY
IMPLIED WARRANTIES ARISING BY WAY OF STATE LAW, INCLUDING ANY IMPLIED WARRANTY OF MERCHANTABILITY OR ANY IMPLIED WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE, ARE
LIMITED IN DURATION AND IN SCOPE OF COVERAGE TO THE TERMS OF THIS LIMITED WARRANTY, UNLESS A SHORTER PERIOD IS ALLOWED BY LAW.
SCRATCH REMOVAL INSTRUCTIONS
1. For eective scratch removal and polishing, you will need to purchase these items.
1 sheet 1000 grit 3M® wet-dry sandpaper
1 sheet 1500 grit 3M® wet-dry sandpaper
1 sheet 2000 grit 3M® wet-dry sandpaper
1 small container of 3M® rubbing compound #05933
These items can be purchased at most auto supply stores that provide supplies to professional paint and body shops. Call
before you go. Not all auto supply stores will have these items.
2. Start sanding with 2000 grit paper. Use small squares of paper about 2" x 2" for all sanding, and use lots of water. The water
serves as both a lubricant and to prevent residue buildup on the paper. Residue buildup shortens the eective life of the paper
and may scratch the surface you’re trying to polish.
3. 2000 grit paper is the nest grit available (the higher the number, the ner the grit). If you can’t remove all of the scratches
with 2000 grit, switch to 1500 grit. Remember to wash the paper frequently with water as you sand.
4. If all of the scratches can’t be removed with 1500 grit, switch to 1000 grit. This should remove most ne scratches. If you have
deep scratches or a gouge, coarser paper may have to be used (see chart to right). Be careful! Using grit that is too coarse may
actually put in more scratches than it removes.
5. Once you have removed all of the scratches, by sanding with the nest paper possible, repeat the sanding process using
successively ner grits of paper until you’ve once again sanded with 2000 grit.
6. Now use 3M® rubbing compound #05933 on a soft, damp cloth. Polish using considerable pressure to produce a
smooth, shiny nish.
LIGHT SCRATCH
1500 – 2000 grit
MEDIUM SCRATCH
1000 – 2000 grit
DEEP GOUGE
600 – 2000 grit
SUPERFICIAL SCRATCH
2000 grit
SCRATCH / SANDPAPER GUIDE
READ BEFORE INSTALLATION AND/OR USE
IMPORTANT SAFETY INSTRUCTIONS
INSTRUCTIONS PERTAINING TO A RISK OF FIRE, ELECTRICAL SHOCK OR INJURY TO PERSON
16. Never drop or insert any object into any opening.
17. Keep all breakable objects out of area.
18. All electrical supply circuits providing the electrical power source to be connected to the whirlpool
or Heated Soaking Bathtub should be checked, installed, and inspected by a licensed electrician and
inspected by the Building Code Authority having jurisdiction at the installation location upon installation
and prior to use of the whirlpool or Heated Soaking Bathtub.
19. The bathtub unit must be connected only to a supply circuit that is protected by a ground-fault circuit-
interruptor (GFCI). Such a GFCI should be provided by the installer and should be tested on a routine basis.
If the GFCI fails to operate properly there may be a ground current owing, indicating the possibility of an
electric shock. Do not use this bathtub unit. Disconnect the bathtub unit and have the problem corrected
by a qualied service representative before using.
20. A green colored terminal is provided within the terminal compartment. To reduce the risk of shock,
connect this terminal to the grounding terminal of your electric service or supply panel with a continuous
green insulated copper wire equivalent in size to the circuit conductors supplying this equipment, but no
smaller than No. 12 AWG (3.3mm).
21. If more than one disconnect switch is required to disconnect all power to bathtub unit, the bathtub
unit shall be marked where readily visible to service personnel prior to disconnecting the main supply for
the bathtub unit with the word "CAUTION" and the following or the equivalent: "Risk of Electric Shock - 2
disconnect switches are required to de-energize the bathtub unit before servicing."
22. Prolonged immersions in hotter water may induce hyperthermia.
23. The causes, symptoms and eects of hyperthermia may be described as follows: Hyperthermia occurs
when the internal temperature of the body reaches a level several degrees above the normal body
temperature of 98.6˚ F. The symptoms of hyperthermia include an increase in the internal temperature
of the body, dizziness, lethargy, drowsiness and fainting. The eects of hyperthermia include: Failure
to perceive heat; Failure to recognize the need to exit the hydromassage bathtub; Unawareness of
impending hazard; Fetal damage in pregnant women; Physical inability to exit the hydromassage bathtub;
Unconsciousness resulting in the danger of drowning
WARNING - The use of alcohol, drugs or medication can greatly increase the risk of fatal hyperthermia.
24. Do not install a timer to the hydromassage bathtub.
25. SAVE THESE INSTRUCTIONS.
1. READ AND FOLLOW ALL INSTRUCTIONS
2. DANGER: To reduce the risk of injury, do not permit children to use this unit unless they are
closely supervised at all times.
3.To avoid over spray from jets the water level must be at least 1" above all jets and intake covers.
4. Infants should not be permitted in the bathtub unit at water temperatures over 100˚ Fahrenheit
and only with prior medical consultation and permission from your doctor.
5. Pregnant women and persons suering from heart disease, diabetes, or high or low blood
pressure should not enter the bathtub unit without prior medical consultation and permission
from their doctor.
6. For your rst whirlpool bath, start with a short duration of ve minutes. You can increase the
time intervals as your body's tolerance adjusts. However, do not use longer than 15 minutes at any
one time.
7. High water temperatures and prolonged periods of use can raise internal human body
temperature excessively and impair the body's ability to regulate its internal temperature.
8. Check whirlpool or Heated Soaking Bathtub before use. Maximum safe temperature is 104˚
Fahrenheit (40˚ Celsius).
9. Observe reasonable time limits to avoid nausea, dizziness, and fainting.
10. Do not direct the water spray to the following body areas in these instances: Any area of the
body that is swollen, burned, inamed or where skin eruptions or ulcerated sores are present. Any
area of the body that is sore unless approved by your doctor. The abdomen when pain is present.
Legs with varicose veins. Calves of legs with unexplained pain.
11. Keep body, hair, and clothing a maximum of 12 inches away from the suction tting at all
times when whirlpool or Heated Soaking Bathtub is operating. Do not operate the unit without
the guard over the suction tting.
12. Do not use whirlpool or Heated Soaking Bathtub while under the inuence of alcohol or
narcotics.
13. Enter and exit the bathtub unit slowly.
14. Do not use electrically connected devices such as televisions, radios, stereo speakers, lights,
cooking devices, hair dryers, telephones, or other electrical appliances within ve feet of the
bathtub unit.
15. Use this bathtub unit only for its intended use as described in this manual. Do not use
attachments not recommended by the manufacturer.
CLEANING
Do not use any abrasive cleaners or metal scrapers. If drywall mud or plaster gets on your whirlpool, it may be carefully removed with a wooden
scraper made from a piece of scrap wood. Adhesive may be removed with mineral spirits. Ideal cleaners are Soft Scrub Gel® or Comet Gel®. FLUSHING
INSTRUCTIONS FOR WHIRLPOOL: Whirlpool unit must be ushed every ninety (90) days with a sanitizing chemical such as a spa freshener, algicide or
household bleach. Fill whirlpool with water, add sanitizing chemical and allow the unit to circulate for at least 20 minutes. Hair dye may stain, do not use.
Do not use sulfuric acid to unclog drain, use plunger or snake to clear obstruction.
WARNING: Some cleaning products are not suitable for use. Read all labels carefully. DO NOT USE if they say “not suitable for use with ABS, acrylic or
polystyrene.”