Installation Instructions

Page 3
13
Side panels are designed to be
ush with front edge of bathtub.
Note: Back corner gaps will be
covered by caddies.
14a
a-Apply adhesive to back of
each corner caddy using a
"S" pattern. Evenly trowel
adhesive.
b-Apply 1/8" bead of adhesive
around back edge of each
corner caddy.
15
Position caddy in corner of
alcove and press rmly in place.
Repeat this procedure with
second caddy on opposite
corner.
Back of
Corner Caddy
14b
Back of
Corner Caddy
Protective
Film
Protective
Film
Protective
Film
Protective
Film
11
Peel back protective lm from all
panel edges and caddy edges to
allow room for caulking.
Caulk all seams with a high
grade color coordinated or clear
caulk. Allow caulk to fully cure
per manufacturer's instructions.
Remove all protective lm.
Protective
Film
16
Apply pressure to panels while
adhesive cures with cross
bracing. Allow adhesive to
fully cure per manufacturer's
instructions. Remove cross
bracing.
10
Evenly trowel adhesive.
Failure to trowel adhesive
will result in an uneven nish.
Follow adhesive manufacturer’s
instructions. Repeat for side
panels.
12
Position back panel and press
rmly in place. Repeat this
procedure for both side panels.
Be careful not to get glue on
nished edges.
Protective
Film
17
Protective
Film
Protective Film
Protective Film
9
Remove panel and apply
adhesive below marked line on
back wall using an "S" pattern.
Repeat for side panels.