Installation Instructions

ManualsBrandsLyons ManualsBathGala Haven 60" x 32" White Bathtub Wall Surround

Page 1

Subject to manufacturing tolerance of [+] or [-] 1/8"

Gala Haven

(GHCSxx)

Kit Includes:

1 - Back Panel

2 - Corner Caddies

2 - Side Panels

NOTE: Back wall panel is 31" x 59" and two side panels are 27" x 59"

DO NOT RETURN PRODUCT!

FOR QUESTIONS OR CONCERNS

please call or e-mail our customer support team

8:00am-4:30pm EST. Monday - Friday

1-800-458-9036

lyonssupport@lyonsindustries.com

SUPPLIES YOU WILL NEED:

6 Tubes of adhesive compatible with polystyrene

1 Tube of color coordinating or clear caulk

Caulk (for faucet installation)

Masking Tape

Material for creating cross bracing (see step 17)

TOOLS YOU WILL NEED:

Tape Measure

Pencil or Marker

Utility Knife

Caulk Gun

Notched Trowel

Safety Glasses

IMPORTANT

• Read installation instructions carefully BEFORE starting project.

• Leave protective lm on during installation.

• Allow panels to reach room temperature before installation.

• Save carton for template.

• Not designed for unheated properties. Freezing temperatures could cause cracking.

• Keep instructions for warranty information.

Summary of content (4 pages)

PAGE 1
DO NOT RETURN PRODUCT! FOR QUESTIONS OR CONCERNS please call or e-mail our customer support team 8:00am-4:30pm EST. Monday - Friday 1-800-458-9036 lyonssupport@lyonsindustries.
PAGE 2
Installation Instructions 1 3 2 Drywall sets above bathtub flange Bathtub Flange Remove faucet handles, trim, faucet spout and shower door/ curtain. 4 Wall surfaces must be SOLID, SMOOTH, CLEAN, DRY and PLUMB. Remove soap residue, loose plaster, paint or wall paper. Wall kit may be installed over existing tile. 6 Place template over faucet controls. "X" side goes against wall. Template should be flush with front edge of bathtub and back wall. If not, cut template to fit. Mark faucet locations.
PAGE 3
10 9 11 ve cti e t Pro Film Remove panel and apply adhesive below marked line on back wall using an "S" pattern. Repeat for side panels. Evenly trowel adhesive. Failure to trowel adhesive will result in an uneven finish. Follow adhesive manufacturer’s instructions. Repeat for side panels. 12 13 ve cti e t Pro Film Back of Corner Caddy Position back panel and press firmly in place. Repeat this procedure for both side panels. Be careful not to get glue on finished edges.
PAGE 4
CLEANING Do not use any abrasive cleaners or metal scrapers. If drywall mud or plaster gets on finished surface, it may be carefully removed with a wooden scraper made from a piece of scrap wood. Any excess adhesive should be cleaned up immediately using mineral spirits or WD-40®. DO NOT USE LACQUER THINNER, it will damage surface of wall. Ideal cleaners are 409®, Soft Scrub Gel®, or Comet Gel®. WARNING: Some cleaning products are not suitable for use. Read all labels carefully.