Users Manual

Zigbee RF Module Description

ZBM

Appearance Description

The picture is shown below, L=32mm, W=15.30mm, H=3.6mm(With the antenna). It has 28 pins,5 on the

leftand23ontheright.Footspacing1.27mm.

And it comes with a standard U.FL antenna seat.

This module can be used not only as patch element, but also as plug‐in.

PAGE 1
Zigbee RF Module Description ZBM Appearance Description The picture is shown below, L=32mm, W=15.30mm, H=3.6mm(With the antenna). It has 28 pins,5 on the left and 23 on the right. Foot spacing 1.27 mm. And it comes with a standard U.FL antenna seat. This module can be used not only as patch element, but also as plug‐in.
PAGE 2
Pin distribution instructions Pin allocation is shown below. these pins are drawn from the peripheral pins of the CC2530 chip of the module. The AS1 and AS2 are idle, the GND and VCC‐3.3V are power supply pins. the voltage input range can support 2.5 V to 3.6 V. standard voltage input 3.3V.
PAGE 3
Product characteristics         Wireless protocol Zigbee IEEE802.15.4 standard, RF range is 2405 MHZ‐2480MHZ The antenna interface is IPEX 1 generation and can be compatible with all kinds of 2.
PAGE 4
          If the FCC ID is not visible when the module is installed inside another device, then the outside of the device into which the module is installed must also display a label referring to the enclosed module. The end product shall haves the words “Contains Transmitter Module FCC ID: 2AHUTZBM”. The device must be professionally installed. The intended use is generally not for the general public. It is generally for industry/commercial use.