User Manual

128
SERIES 900
SECTION 2900
Mold to Width 29 mm Square Friction Top
in. mm
Pitch 1.07 27.2
Molded Width 1.1 29
Hinge Style Closed
Drive Method Center-driven
Product Notes
• Always check with Customer Service for precise
belt width measurement and stock status before
designing a conveyor or ordering a belt.
• Available only in Square Friction Top Ultra (SFT Ultra)
(higher rubber concentration).
• Two material rubber modules provide a high friction
surface without interfering with carryways and sprockets.
• Available in black rubber on grey polypropylene and
black rubber on grey or blue acetal.
• Not recommended for back-up conditions. If friction
values between product and belt are required, contact
Intralox Sales Engineering.
• Black Rubber/PP modules have a hardness of 45 Shore
A. Black Rubber/AC modules have a hardness of 54
Shore A.
Additional Information
• See “Belt selection process” (page 5)
• See “Standard belt materials” (page 18)
• See “Special application belt materials” (page 18)
• See “Friction factors” (page 31)
Belt Data
Belt Material Standard Rod
Material
Ø 0.18 in.
(4.6 mm)
BS
Belt
Strength
Temperature Range
(continuous)
W
Belt
Weight
Agency Acceptability:
1=White, 2=Blue,
3=Natural, 4=Grey
lb kg °F °C lb/ft kg/m FDA (USA)
J
a
Polypropylene (SFT Ultra) Nylon 65 29 34 to 150 1 to 66 0.17 0.25
Acetal Nylon 140 64 -10 to 130 -23 to 54 0.21 0.31
a. Japan Ministry of Health, Labour, and Welfare