Assembly guide

Step 14. If you are using the SP-560 speed
controllers cut off the connectors and install the
stake-on connectors as shown. I also remove the
power switch and hardwire them on. Use foam
double sided tape to mount the controllers inside
the body. If you follow the color code the motor
rotation direction should be correct.
Figure 17. Figure 16.
Remote control
The speed controllers provide the power for the RC
receiver. You need to pull the red wire from one of
the two speed controllers (see figure 18 and 19). If
both of the speed controllers try to power the RC
receiver one of their regulators will be damaged.
Then, simply plug the two speed controllers into
the RC receiver and away you go!
Microcontroller control
You should pull both of the red wires from the
speed controllers when connecting them to the
Next Step (see figures 18 and 19). This will prevent
damage to either the Next Step or the SP-560s.
Figure 18. Figure 19.