Assembly guide

Step 11. Install the front scoop mount plate as
shown. Use 4 of the 4-40 x 3/8 screws. Depending
on how you configure your scoop you may need to
reinforce this, or make another from aluminum
using this as a template.
4 x
Figure 13.
Step 12. Install the fenders as shown.
8 x
Figure 14.
Step 13. Here is a simple way of wiring the drive
system. Crimp the connectors and install them as
shown. In the middle is a mating connector for the
7.2vdc and 8.4vdc batteries. Use foam double sided
tape to hold the terminal strip inside the
compartment.
Figure 15.